Removing The Transportation; Safety Assembly; Under Counter Installation; Connecting To The Drain - Grundig GTN 37114 GP User Manual

4.2 Removing the transportation

safety assembly

A
CAUTION: Remove the
transportation safety
assembly before using the
product for the first time.
1. Open the loading door.
2. There is a nylon bag inside the
drum that contains a piece
of styrofoam. Hold it from its
section marked with XX XX.
3. Pull the nylon towards yourself
and remove the transportation
safety assembly.
A
CAUTION: Check that no
part of the transportation
safety assembly remains
inside the drum.

4.3 Under counter installation

• This product can be installed
under a counter if the height of
the counter is sufficient.
A
CAUTION: While using the
under counter dryer, never
operate the dryer without
under counter installation
part.
Dryer Depth
Stock number of under-
bench installation part
• Leave at least 3 cm of space
around the sides and the
rear wall of the product when
installing it under a counter or in
a cupboard.
60 cm 54 cm
2979700200 2973600200

4.4 Connecting to the drain

In products equipped with condenser
unit, water accumulates in the water
tank during the drying cycle. You
should drain accumulated water
after each drying cycle.
You can directly drain accumulated
water through the water drain hose
supplied with the product instead
of periodically draining the water
collected in the water tank.
1
3
Connecting the water drain hose
1-2 Pull hose at the behind of the
dryer by hand in order to disconnect
it from where it is connected. Do not
use any tools to remove the hose.
3 Connect one end of the drain
hose supplied with the dryer to the
connection point from where you
removed the hose of the product in
previous step.
4 Connect the other end of the drain
hose directly to the wastewater drain
or to the washbasin.
2
4
EN
RO
15