Dynacraft MOUNTAIN BIKE Owner's Manual page 32

12. ACCESSORIES
C
Your bike may come with some or all of these accessories that require attachment
and/or assembly.
12A. Kick Stands
If the kickstand is not mounted to your bicycle, place the bicycle in an upright
position against a wall or have someone hold it upright. Place the kickstand in the
bracket mounted on the frame and use a pair of (E) Standard Slip Joint Pliers to
secure the fixing bolt to keep the kickstand in place. Be sure to tighten the fixing
bolt securely. Some kickstands use a top plate to locate the bolt and secure the
kickstand using a fixing bolt. Be sure to tighten the axle nut. The guard will sit
between the frame and the axle nut (see Figure 49).
WARNING:
The kickstand is designed to
support the BICYCLE ONLY; not the bicycle and the rider.
12B. Rear Derailleur Guard
Some 20", 24" and 26" model bicycles come
with a rear derailleur guard to protect the rear
derailleur from damage. To install, remove the
rear wheel axle nut on the drive side, install
the rear derailleur guard over the axle with the
U-shaped guard pointing down, and retighten
the axle nut. The guard will sit between the
frame and the axle nut (see Figure 50).
Figure 50
12C. Other Accessories
For all other accessories, either follow the instructions on the packaging in order to install,
Figure 49
32
or bring your bike to a qualified bicycle shop in order to have the part safely installed.