Testing Brake Functions - Dynacraft MOUNTAIN BIKE Owner's Manual

C

8. TESTING BRAKE FUNCTIONS

As part of the initial assembly, you will need to check test
the brake function and adjust the brakes as necessary
to make sure they are functioning properly. For detailed
instructions on brake adjustments, please see pages 35–37.
Front brake Rear brake
To test the function of the front hand brake, lift the front of
the bike and spin the wheel. The wheel should not rub on
the brake pads. Next, squeeze the brake lever and take
Figure 36
note of the brake pads contacting the side of the wheel.
The pads should contact the rim on both sides at the same
time. Finally, hold the brake lever firm and try to move the
bike forward. The brake should hold well enough to keep the
wheel from moving. Repeat these steps for the rear wheel
(see Figure 36).
Figure 37
27