Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1
Unfolding the Handle
No Parts Required
Procedure
1. Loosen the handle knobs, pull out the U-shaped handle
locks until you can move the handle freely, and rotate
the handle to the operating position
1. U-shaped handle lock (2)
2. Insert the end of the U-shaped handle lock into the
open hole in the handle and tighten the handle knobs
until they are snug
Note: The handle knobs contain nyloc nuts that
require more pressure to tighten fully to prevent the
handle from coming loose during operation.
Description
No parts required
Screw
Chute assembly
Discharge-chute handle
(Figure
4).
Figure 4
2. Handle knobs
(Figure
5).
Qty.
–
Unfold the handle.
3
1
Install the discharge chute.
1
Important: Ensure that you do not pinch or kink
the control cable
1. Control cable
4
Use
Figure 5
(Figure
6).
Figure 6