Filling The Engine With Oil; Installing Discharge Chute - Toro Power Clear 721 QZE Operator's Manual

2
Installing the Discharge Chute
Parts needed for this procedure:
3
Screw
1 Chute assembly
1 Discharge-chute handle
Procedure
Install the discharge chute as shown
1. Discharge chute
Note: For easier installation, use a small ratchet wrench to
tighten the screws.
Important: Do not overtighten the screws; otherwise
you may damage the discharge chute and prevent it
from turning freely.
3

Filling the Engine with Oil

No Parts Required
Procedure
Your machine does not come with oil in the engine, but it
does come with a bottle of oil.
Important: Before starting the engine, fill the engine
with oil.
Note: The bottle of oil may contain more oil than is required.
Do not overfill or under fill the engine.
(Figure 7).
Figure 7
2. Screw (3)
Max fill:. 0.60 L (20 oz), type: automotive detergent oil with
an API service classification of SJ, SL, or higher.
Use Figure 8 below to select the best oil viscosity for the
outdoor temperature range expected.
1. Move the machine to a level surface.
2. Clean around the oil-fill cap
1. Oil-fill cap
3. Unscrew the oil-fill cap and remove it.
4. With the machine in the operating position, carefully
pour oil into the crankcase until the point of overflow.
Note: You may tip the machine forward (handle up)
to make adding oil easier. Remember to return the
machine to the operating position before checking the
oil level.
Important: Do not tip the machine all the way
forward onto its nose, or fuel may leak out of the
machine.
5. Wait 3 minutes for the oil to settle and add enough to
bring it to the point of overflow.
6. Screw the oil-fill cap into the oil-fill hole and tighten it
securely.
5
Figure 8
(Figure 9).
Figure 9