Mixer Functions - DAPAudio Core Kontrol D2 Manual

Core Kontrol D2

Mixer Functions

33) Track select encoder
Depending on the browser panel (see page 22) you are in, you can use the encoder to select a
certain track or folder. Confirm your choice by pressing the encoder.
34) Load A button
Pushing this button loads the selected track in deck A and activates the cue function for channel 1.
The cue 1 (39) button will light up.
35) Channel 1 gain
The gain control allows you to adjust the input-sensitivity for a channel and thus optimally match the
incoming signals to the mixer's internal operation level.
36/37/38) Channel 1 equalizer section (HI / MID / LOW)
Use the 3-band equalizer to adjust tone for each channel by using the Hi, Mid and Low controls. Push
a control to kill (mute) the corresponding band.
39) Cue 1 button
Tapping this button will allow the audio from that channel to be cued in the headphones. Selecting
cue 1 will deselect cue 2. Please ensure that headphones volume (55) is not completely turned
down.
40) Channel 1 fader
The fader controls the volume of the corresponding channel.
41) X-Fader slope switch
Allows you to select the response (cut/linear) of the cross fader.
42) Cross fader
The crossfader allows you to mix smoothly from one source to another (only when
both faders are up).
43) Load B button
Pushing this button loads the selected track in deck B.
44) Back button
This button in combination with the track select (33) encoder allows you to navigate through the
browser panels. See page 13: "01) Selecting folders" and "02) Selecting tracks"
45) Channel 2 gain
The gain control allows you to adjust the input-sensitivity for a channel and thus optimally match the
incoming signals to the mixer's internal operation level.
46/48/50) Channel 2 equalizer section (HI / MID / LOW)
Use the 3 band equalizer to adjust the tone for each channel by using the Hi, Mid and Low controls.
Push a control to kill (mute) the corresponding band.
47) Master Level
Use to adjust the volume level of the master RCA (60) or the master XLR (61) outputs.
Note: This is an analog control and does not send MIDI commands.
49) Cue mix control
Allows the user to hear mixed audio of the monitor (cue) audio and the program (master) audio in
the headphones. When the control is rotated to the left only the cue audio will be heard, when
rotated to the right, only the program audio will be heard.
Note: This is an analog control and although it does send MIDI commands, this control is not
represented in the Virtual DJ LE software GUI.
51) Cue 2 button
This button will allow the audio from that channel to be cued to the headphones. Please ensure that
headphones volume (55) control is not turned down completely.
52) Channel 2 fader
The fader controls the volume of the corresponding channel.
Ordercode: D1261
11