Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1
Saving the preparation time:
2. Press button F once.
The display flashes. LED 1 (preparation
step 1) lights up in the control panel.
3. Keep pressing button F until the desired
preparation time is displayed.
When button F is briefly pressed, the prepa-
ration time is increased by 1 minute. When
button F is pressed for a longer period, the
preparation time is increased by 10 minutes.
The time increases up to the pre-configured
maximum value and then returns to the
pre-configured minimum value.
Saving the preparation temperature or
steam pressure:
4. Preparation temperature: Press
button C once. The pre-configured
preparation temperature is shown in the
display. Press button C repeatedly until
the desired preparation temperature is
displayed.
or
Steam pressure: Press button L to
switch between [ K ] and [ L ].
5. Press and hold button G (>2 seconds)
to save the set values.
Note: Either the temperature or the steam
pressure can be set and stored for one
preparation step. The value last selected
is saved.
In order to programme other preparation
steps, repeat points 2 to 6. Up to 3
preparation steps can be programmed.
The saved preparation programme
[ рецепт 1 ] (recipe 1) can be selected as
usual via function selection mode.
Note: To save a second personal
preparation programme under [ рецепт 2 ]
(recipe 2), use the same process as
described above for [ рецепт 1 ] (recipe 1).
To delete a personal preparation
programme, perform the following steps:
1. In function selection mode, press
button D once.
The LED [ рецепт 1 ] (recipe 1) lights up.
The saved preparation time is shown in the
display.
MUC6-8_RU_8001018000.indb 21
2. Press button F once.
The display flashes. LED 1 (preparation
step 1) lights up in the control panel.
3. Press and hold button H (>2 seconds).
The settings for [ рецепт 1 ] (recipe 1) are
deleted.
Note: To delete the second personal
preparation programme [ рецепт 2 ]
(recipe 2), use the same process as
described above for [ рецепт 1 ] (recipe 1).

Child lock

The child lock can be activated and
deactivated during a preparation process.
If the child lock has been activated, all
buttons on the control panel are locked
and settings can no longer be made on the
appliance.
W Warning
When the child lock is active, the prepa-
ration processes cannot be changed
or terminated. The child lock must be
d eactivated first.
Press the following button combination:
1. Activate
Press and hold buttons C and F
simultaneously for 3 seconds. A short
audible signal sounds. The child lock is
activated.
2. Deactivate
Press and hold buttons C and F
simultaneously for 3 seconds once
again. A short audible signal sounds.
The child lock is switched off.
Child lock
en
21
07.03.2016 10:38:02

Advertisement

Table of Contents
loading

This manual is also suitable for:

Muc8...ru

Table of Contents