Customised Setting Options - Bosch MUC6...RU Instruction Manual

8. Press button G to start the preparation
programme.
Once the preparation programme ends,
an audible signal sounds and button G
flashes.
9. Open the lid of the appliance.
10. Lift the top part and the bottom part of
the steamer insert out of the pan.

Customised setting options

The pre-configured values for the prepara-
tion time and the preparation temperature
or steam pressure can be adapted to indi-
vidual needs and the recipe guidelines.
Setting the preparation time
1. In function selection mode, keep
pressing button D until the desired
preparation programme is selected.
The corresponding LED lights up in the
control panel and the pre-configured prepa-
ration time for this preparation programme
is shown.
2. Press button F once.
The pre-configured preparation time flashes
in the display.
3. Keep pressing button F until the desired
preparation time is displayed.
When button F is briefly pressed, the
preparation time is increased by 1 minute.
The time increases up to the pre-configured
maximum value and then returns to the
pre-configured minimum value. When
button F is pressed for a longer period,
the preparation time is increased by
10 minutes.
4. Once the desired preparation time is
displayed, press button G.
The preparation programme with the set
preparation time is started.
If the time needs to be adjusted individually
for all preparation steps in a selected
programme, then repeat points 2 to 4 prior
to starting the respective preparation step.
Note: These settings are not saved. If this
preparation programme is selected again,
the pre-configured preparation time will be
shown in the display once more.
MUC6-8_RU_8001018000.indb 19
Customised setting options
Setting the preparation
temperature
For preparation programmes without the
steam pressure function, the temperature
can be selected individually.
1. In function selection mode, keep
pressing button D until the desired
preparation programme is selected.
The corresponding LED lights up in the
control panel and the pre-configured prepa-
ration time for this preparation programme
is shown.
2. Press button C once.
The pre-configured preparation temperature
flashes in the display.
3. Keep pressing button C until the desired
preparation temperature is displayed.
When button C is briefly pressed, the
preparation temperature is increased by
5°C. The temperature increases up to the
pre-configured maximum value and then
returns to the pre-configured minimum
value. When button C is pressed for a
slightly longer period, the temperature is
increased by 10°C.
4. Once the desired preparation
temperature is displayed, press
button G.
The preparation programme with the set
preparation temperature is started.
If the temperature needs to be adjusted
individually for all preparation steps in a
selected programme, then repeat points
2 to 4 prior to starting the respective
preparation step.
Note: These settings are not saved. If this
preparation programme is selected again,
the pre-configured preparation time will be
shown in the display once more.
en
19
07.03.2016 10:38:02