Jenn-Air W122 Use And Care Manual page 23

• The oven racks and rack supports can be cleaned in the oven. However, the oven
racks and rack supports will discolor, lose shininess, and become more difficult
to slide in and out if left in the oven during the cleaning process. REMOVE
RACKS AND RACK SUPPORTS FROM OVEN IF THIS DISCOLORATION
WILL BE OBJECTIONABLE. As a suggestion, do not leave the racks in the oven
during each self-cleaning process if they do not need to be cleaned since they
will discolor to a dull silver after many cleanings. Be sure to read special tips
on page 25 if oven racks are cleaned during the self-cleaning process.
• Be sure metal cover plate ws covering the receptacle tor the MEAL TEMP probe.
Steps to Follow for Self-Cleaning Process
1. Turn SELECTOR knob to CLEAN.
2. Turn TEMPERATURE knob fully clockwise
to CLEAN until it comes to a full stop. The
door cannot be locked if TEMPERATURE
knob is not in the CLEAN position.
3. To set timer for desired cleaning time, use
one of the following procedures:
To set oven to start cleaning immediately:
a. Check START dial to be certain pointer is at the same time of day as the
oven clock. If not, turn until knob pops out and cannot be turned.
b. Push in and turn STOP time dial 2 to 21/2hours beyond time indicated on the
clock to clean an average soiled oven. If heavily soiled, set ahead 3 hours.
To set oven to start cleaning at a later time:
a. Push in and turn START dial to the time desired for the self-cleaning process
to begin.
b. Push in and turn STOP dial to 2 to 21/2hours beyond time set for start. If oven
is heavily soiled, set ahead 3 hours.
4. Close oven door.
5. Depress DOOR LOCK SWITCH on control panel. Simultaneously, move DOOR
LOCK LEVER to the full right position; then release DOOR LOCK SWITCH.
23