Error Codes - Texas Smart G-Force SB900 User Manual

Error codes

No. Notification
1
2
3
4
5
6
Notification type
EF 01 Warning
notification
EF 02 Warning
notification
EF 03 Warning
notification
EF 04 Warning
notification
EF 05 Warning
notification
EF 06 Warning
notification
Symptom
Means that the
obstacle sensor is
constantly
activated.
The robot has been
tilted over.
This notification is
only shown in the
error menu.
The robot has been
tilted over.
The robot is
trapped/stuck.
The robot has been
lifted while
operating.
The robot has been
beyond the
boundary cable.
53
Solution
Check to see whether there
are any foreign bodies stuck
on the undercarriage of the
robot.
Check to see whether
inclines are too steep or too
wet for the robot to drive up.
If required, avoid the area
by moving the boundary
cable.
Carry the robot over to a flat
area and restart it.
If the obstacle sensor has
been activated 10 times
within a minute, this
notification will be
generated.
Check to see if the robot is
stuck between trees or
something else.
Check to see whether the
grass is higher than 60 mm.
Check that the robot is free
of foreign bodies.
1. If the robot is inside the
boundary cable area,
check that the cables
are correctly fitted to
the charging station.
2. If the robot is outside
the area, lift it and place
it inside the area again
and restart the robot.
3. If the robot moves
outside the area at a
corner, ensure that the
corner is not more than
a 90° angle.
4. If the robot moves out
of the area repeatedly
at the same location,
check to see if there is
a 230 V cable close by
or buried in the ground.
If this is the case, the
area should be avoided
by moving the
boundary cable.