Tray 2 (Lower Tray) - Ricoh G147 Service Manual

TRAY SHIFTING

Tray 2 (Lower Tray)

[C]
[A]
[E]
[D]
[B]
B352D105.WMF
In sort/stack mode, tray 2 [A] moves from side to side to separate the sets of prints.
The shift mechanism for tray 2 is similar to that used for tray 1. However, when the
tray 2 shift motor [B] turns on, the arm [D] moves the entire end fence [C] from side
to side (not just the tray).
After the gear disk has turned 180 degrees, the cut-out in the gear disk enters the
tray half-turn sensor [E], and the motor stops. When the next set of prints is
delivered, the motor turns on again, and moves the tray back to its previous
position.
G838 22 SM