Ricoh G147 Service Manual page 218

pages prescribed with SP3905 002 have been printed.
[0~1/1/1]
All fans remain on during cleaning and then switch off 60 sec. after the cleaning
cycle ends. Raising this setting can increase wear on the hot roller and cleaning
roller and shorten the service life of the hot roller.
Number of Pages
This SP prescribes the number of pages to accumulate before the fusing motor is
switched on/off (1 cycle).
[0~5/5/13]
002
Unless you change this setting, 15 sec. after a total of 5 pages have been printed
(the accumulated total of one or more small jobs), or after a job of no more than
29 pages, the fusing motor will switch on for 15 sec. and then switch off. This 15
sec. off/15 sec. on at the end of a cleaning job is the 1st Cleaning.
No. of addtnl. shee
This SP prescribes the number of pages to print continuously before the fusing
motor is switched on/off twice.
003
[6 ~ 49 / 30 / 1]
Unless you change this setting, 15 sec. after the end of every print job of 30 to 99
continuous pages, the 1st Cleaning will be done twice (fusing motor is switched
on/off twice at 15 sec. intervals).
No. of addtnl. shee
This SP prescribes the number of pages to print continuously before the 1st
Cleaning is done once at the end of the print job, pauses 45 sec., and then
executes again.
004
[50 ~ 999/ 100 / 1]
Unless you change this setting, 15 sec. after the end of every print job of 100 to
999 continuous pages, the fusing motor will switch on for 15 sec., switch off for 4
sec. switch on for 15 sec. and then switch off. Switching the fusing motor on again
for 15 sec. after 45 sec. have elapsed after the 1st Cleaning is called the 2nd
Cleaning.
G147
Number additional sheets for 2nd hot roller stripper
cleaning
Number additional sheets for 3rd hot roller stripper
cleaning
5-28 SM