Adjusting The Thread Loop Support - Pfaff 3307-1 SERIES Instruction Manual

Adjustment
13

Adjusting the thread loop support

.20
● Switch on the machine and bring the needle into the relevant position (value "1, 2 or 3")
● Adjust thread loop support 1 (screws 2) in accordance with the requirement.
● Switch off the machine.
13 - 20
Requirement
Both at the extreme right point of penetration and at the extreme left point of penetration
the needle should be at a distance of approx. 0.5 mm from the thread loop support 1.
Fig. 13 - 18
with parameter "610".
The thread loop support 1 is also used as a knife guard.
1
2
0,5 mm