Set-up
9
Winding the bobbin thread, adjusting the thread tension
.02
Fit the empty bobbin 1 onto the bobbin winder spindle 2 with the rest thread chamber on
Thread in the thread as shown in Fig. 9 - 02 and wind it round the bobbin 1 a few times in
Switch on the bobbin winder by pressing the bobbin winder spindle 2 and the lever 3
The tension of the thread on the bobbin 1 can be adjusted with the knurled thumb
The bobbin winder stops automatically when the bobbin 1 is suffi ciently full.
Remove the fi lled bobbin 1 and cut the thread with the knife 5.
The fi ll amount of the bobbin 1 can be adjusted with the pin 8 (loosen the screw 9 and
Loosen the nut 6.
Turn the thread guide 7 accordingly.
Tighten the nut 6.
40
1
5
3
9
2
8
Fig. 9 -02
the outside.
an anti-clockwise direction.
simultaneously.
The bobbin fi lls up during sewing.
If the machine is only run for bobbin winding (without sewing), a bobbin case
must be fi tted in the hook!
Otherwise a jammed thread may damage the hook!
screw 4.
tighten it again)
If the thread is wound unevenly:
4
7
6