Connecting The Remote Control - EFOY 600 User Manual

4. Installation
unit
– – +
–
12 V lead
12 V Bleiakku
battery
1
3
1 Control panel
2 Surface mount
3 Frame
4 Screws
Make sure that the polarity is correct (see illustration).
+
Connect the positive wire + and the positive sensor cord
+ to the battery fuse. Then connect the battery fuse to
the battery's positive terminal.
Then connect the negative wire – and the negative
sensor cord to the battery's negative terminal.
Installation in recreational vehicles (RV)
See IM1 installation manual for RVs with Electroblock
+
(EBL).
4.6

Connecting the Remote Control

The remote control (1) displays the current status and
is used to control the device. Mount the panel where it
is easily accessible such as in the cockpit.
If installing the panel flush with the surface of the unit,
make sure that there is sufficient opening for the
electronic components behind the opening.
Use templates for drilling and sawing when flush or
2
surface mounting (2). Use a drill to start the opening
and then cut out the rest of the opening with a keyhole
or compass saw.
Then secure the control panel (1) with four suitable
screws (4) and place the frame (3) over the control
panel
4
19