Table of Contents
Advertisement
Protection
Aggregation
Short GI
WLAN Partition
STBC
LDPC
20/40MHz Coexist
It is recommended to enable the protection mechanism. This
mechanism can decrease the rate of data collision between 802.11b
and 802.11g wireless stations. When the protection mode is enabled,
the throughput of the AP will be a little lower due to the transmission of
heavy frame traffic.
Default is "Disabled".
It is a function where the values of multiple rows are grouped together.
Default is "Enabled"
It is used to set the time that the receiver waits for RF reflections to
settle out before sampling data.
Default is "Enabled"
This feature also called "WLAN isolation" or "Block Relay". If this is
enabled, wireless clients cannot exchange data through the
WNAP-W2201A.
Default is "Disabled".
Activate Space Time Blocking Code (STBC) which does not need
channel statement information (CSI).
Default Setting: "Enabled"
Low-density Parity-check Code is wireless data transmit algorithm.
Default Setting: "Enabled"
Configure 20/40MHz coexisting scheme.
If you set up as "Enabled", "20MHz" and "40MHz" will coexist.
Default Setting: "Disabled"
-45-
User Manual of WNAP-W2201A
Advertisement
Table of Contents
