When Another Interface Is Connected - Epson TM-T88VI Technical Reference Manual

When Another Interface is Connected

DIP Switch Bank 1
SW
1-1 Auto line feed
1-2 Receive buffer capacity
Selects paper sensors to output
1-3 paper-end signals (default value of a
command)
1-4 Error signal output
1-5 
Undefined
1-7
1-8 USB power saving function
* This is enabled only when the communication status for the USB interface is set in the vendor definition class,
and the system configurations under which USB drivers support USB power saving functions.
DIP Switch Bank 2
SW
2-1 Handshaking (BUSY condition)
2-2 Reserved (Do not change setting)
2-3 
Selects print density
2-4
Sets the release condition of the
receive buffer BUSY state. (This
2-5
function is effective when DIP Switch
1-2 is set to off.)
2-6 
Reserved (Do not change settings)
2-7
Reserved (Do not change settings)
2-8
IF pin 31 reset signal
For DIP Switch 2-1 (BUSY condition), see also
58
Function
Always enabled
Function
Receive buffer full
See "Selecting the Print Density (DIP Switches 2-3/
2-4)" on page
Releases the BUSY state
when the remaining
capacity of the receive
buffer reaches 138 bytes.
ON OFF
Always disabled
45 bytes 4 KB
Roll paper end sensor
Disabled enabled, roll paper near-
end sensor enabled
Disabled Enabled
—
Disabled Enabled*
ON OFF
 Offline
 Receive buffer full
Fixed to OFF
59.
Releases the BUSY state
when the remaining
capacity of the receive
buffer reaches 256 bytes.
Fixed to OFF
Fixed to OFF
Fixed to ON
"Selecting the BUSY Status" on page
Default
setting
OFF
OFF
OFF
OFF
OFF
OFF
Default
setting
OFF
OFF
OFF
OFF
OFF
OFF
ON
59.