Epson TM-T88VI Technical Reference Manual page 57

DIP Switch Bank 2
SW Function
2-1 Handshaking (BUSY condition)
2-2 Reserved (Do not change setting)
2-3 
Selects print density
2-4
Sets the release condition of the
receive buffer BUSY state. (The
2-5
reception buffer capacity is effective
when set to 4 KB.)
2-6 Reserved (Do not change setting)
2-7 I/F pin 6 reset signal
2-8 IF pin 25 reset signal
 For DIP Switch 2-1 (BUSY condition), see also
 When you use the APD, change the setting of DIP switch 2-1 (BUSY condition) to ON.
ON
 Offline
Receive buffer full
 Receive buffer full
Fixed to OFF
See "Selecting the Print Density (DIP Switches 2-3/
2-4)" on page 59.
Releases the BUSY state Releases the BUSY state
when the remaining when the remaining
capacity of the receive capacity of the receive
buffer reaches 138 bytes. buffer reaches 256 bytes.
Fixed to OFF
Enabled
Enabled
"Selecting the BUSY Status" on page
Chapter 3 Advanced Usage
Default
OFF
setting
OFF
OFF
OFF
OFF
OFF
Disabled OFF
Disabled OFF
59.
3
57