Ordering Parts; Repair Notes - Icom IC-F6061 Service Manual

This service manual describes the latest service information
for the IC-F6061/F6061D/F6062/F6063 UHF TRANSCEIVER
at the time of publication.
MODEL VERSION
USA-01
USA-02
IC-F6061
USA-03
USA-04
USA-01
IC-F6061D
USA-02
EUR-01
IC-F6062
EUR-03
EXP-01
EXP-02
IC-F6063
EXP-03
EXP-04

ORDERING PARTS

Be sure to include the following four points when ordering
replacement parts:
1. 10-digit Icom parts numbers
2. Component part number and name
3. Equipment model name and unit name
4. Quantity required
<SAMPLE ORDER>
1110003491 S.IC
8820001210 Screw 2438 screw
Addresses are provided on the inside back cover for your
convenience.
Icom, Icom Inc. and
Kingdom, Germany, France, Spain, Russia and/or other countries.
fineline6
INTRODUCTION
FREQUENCY
DESCRIPTION
RANGE
400−470 MHz
(Low band)
–
450−512 MHz
(High band)
400−470 MHz
(Low band)
MDC compatible
450−512 MHz
(High band)
400−470 MHz
MDC compatible
(Low band)
&
450−512 MHz
UT-126H installed
(High band)
400−470 MHz
–
(Low band)
400−470 MHz
MDC compatible
(Low band)
400−470 MHz
(Low band)
–
450−520 MHz
(High band)
400−470 MHz
(Low band)
MDC compatible
450−520 MHz
(High band)
TA31136FNG IC-F6061 MAIN UNIT
IC-F6062 Top cover
logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United
NEVER connect the transceiver to an AC outlet or to a DC
power supply that uses more than 15 V. This will ruin the
transceiver.
TX
DO NOT expose the transceiver to rain, snow or any liquids.
POWER
DO NOT reverse the polarities of the power supply when
connecting the transceiver.
DO NOT apply an RF signal of more than 20 dBm (100 mW) to
the antenna connector. This could damage the transceiver's
front end.
45 W
To upgrade quality, any electrical or mechanical parts and
internal circuits are subject to change without notice or
obligation.
25 W
1. Make sure the problem is internal before disassembling
the transceiver.
2. DO NOT open the transceiver until the transceiver is
disconnected from its power source.
3. DO NOT force any of the variable components. Turn
them slowly and smoothly.
4. DO NOT short any circuits or electronic parts.
insulated tuning tool MUST be used for all adjustments.
5. DO NOT keep power ON for a long time when the
transceiver is defective.
5 pieces
6. DO NOT transmit power into a signal generator or a
10 pieces
sweep generator.
7. ALWAYS connect a 50 dB to 60 dB attenuator between
the transceiver and a deviation meter or spectrum
analyzer when using such test equipment.
8. READ the instructions of test equipment thoroughly
before connecting equipment to the transceiver.
CAUTION

REPAIR NOTES

An