Mighty Mule MM360 Installation Manual page 27

Step 7
3
Strip / " off the ends of the low
16
voltage transformer wire and twist
tightly. Insert these ends to the 18 VAC
terminal block located on the control
board (see illustration at right).
Be certain not to let the exposed
wires touch each other!
Tighten set screws against exposed end
of wires.
Wrong
Correct
Wire Screwed into
wire insulation
Step 8
At the transformer ends of the transformer wires, strip
1/2" of insulation from the ends of the low voltage
wire. Attach these stripped ends to the transformer
terminals.
Make sure the exposed wires do not
touch each other!
Step 9
Plug the transformer into the electrical outlet. Use of a surge
protector with the transformer is strongly recommended. If
electrical outlet is located outdoors, outlet and transformer
should be protected by a weatherproof cover.
H L 18VAC/
AUX
SOLAR
OUT
INPUT
Wrong
Exposed strands
of wire
CHARGING
POWER
LINK
NOTE: The Mighty Mule power input is
not polarized. The wires can be inserted
into either terminal regardless of color.
Low Voltage Wire
from Transformer
Transformer
Mighty Mule MM360 Installation Instructions
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
RF
RCVR
23