Huawei EchoLife HG520 User Manual page 72

re-transmits them on another port. A bridge will not start
re-transmission until it receives a complete packet. Because of this,
station on either side of a bridge can transmit packets simultaneously
without causing collisions. This page allows you to configure wireless
bridge features of the wireless LAN interface.
Follow the steps below to configure wireless bridge.
1. Select Access Point or Wireless Bridge from AP Mode.
Select Wireless Bridge will disables access point
functionality, while select Access Point enables access
point functionality.
2. Select Enabled (Scan) from Bridge Restrict will enable the
wireless bridge restriction and only those bridges selected in
Remote Bridges will be granted access. Select Disabled in
Bridge Restrict which disables wireless bridge restriction and
any wireless bridge will be granted access.
Huawei Technologies Proprietary
Figure 4-47
66