Table of Contents
Advertisement
■ Example
6
2
Guidelines for the installation board
thickness:
・BLF-2000 / BLF-5000: 8 mm or more
・BLF-7000 Series: 10 mm or more
■ Precautions
● Please read this instruction manual thoroughly before use to ensure proper operation.
● On any commercial power supply, install a ground-fault interrupt breaker and safety circuit
breaker.
● Connect the power supply to ground and use only the rated voltage.
● Please consider every condition such as power loss and inertia due to the Joint Shaft part,
etc. from the body to the bit of the screwdriver. Make sure to select the screwdriver that well
meets the requirements.
● In case a universal joint or jigs are used, the actual output torque values may be different
from the corresponding torque values displayed on the specification table.
● Please confirm that the screwdriver and the power supply are the right combination.
● The overload protection will be activated when the screwdriver is locked or has become
overloaded. If the screwdriver is overloaded repeatedly, the maximum ratings of the power
supply or screwdriver may be exceeded. If the screwdriver becomes overloaded during normal
operation or begins to malfunction due to developing excessive heat, stop the ongoing operation
immediately, turn the main power switch off, remove the power cable, and contact our service
department or HIOS distributor for repairs.
● When fastening screws on workpieces constructed of plastics susceptible to static electricity
build-up, operation should be done after static electricity has been discharged. If the work
pieces that have not been properly discharged, static electricity may flow up through the
end of the bit, causing malfunctions of the tools.
● Do not disassemble or modify the tools in any way, as doing so may cause malfunctions of the
tools. Such malfunctions are not covered by the HIOS warranty and repairs may be refused.
● The operating environment for the screwdriver should be between 5̊C and 40̊C with
relative humidity of 80% or less (there should be no possibility of condensation).
● Do not drop the tools or subject it to mechanical shocks.
● Always hold the plug when inserting or removing power cables or the driver cords into or from
sockets.
● Do not drag cords or cables, subject them to oil or to sharp edges, or place them under
heavy objects.
● If the tools will not be used for a long period of time, turn the main power switch OFF and
unplug it from the service outlet.
1. For the thickness of
the installation board
of the back board,
appropriate thickness
under the installation
conditions should be
kept when fixing.
- 6 -
2. For the thickness of
the installation board,
appropriate thickness
under the installation
conditions should be
kept when fixing.
Z軸
Y軸
3. When connecting an Angle to the
Z-axis, fix it firmly. If it is loosely
fixed, it may cause problems such as
overload.
Advertisement
Table of Contents
