Advertisement
Available languages
Available languages
•
Assemble the gasket (14) into the bowl
(2) making sure that the flat surface of
the gasket (14) is facing the top. Align
the bowl (2) with the gasket (14) to the
motor (1), so that the juice spout (f) was
placed exactly in the casing (1) groove
and 4 buckles from the upper part of the
motor (1) were placed inside the 4
grooves in the bottom of the bowl (2).
•
Align the insert (3) to the bowl (2) so
that the fin (g) of the insert (3) is placed
in the cutting of the bowl (2) over the
juice spout. Put the filter (4) inside and
check if it is well mounted and rotates
easily
•
Put the lid (5) so that the fin (g) of the
insert (3) was placed in the cutting of
the lid (5)
•
Pull the locking bar (6) up, so that the
rolls moved into grooves of the lid (5)
from position 2 to position 1( you will
hear a characteristic clicking sound).
•
Put the bowl for the small fruits (7) on
the chute of the lid (5) when necessary.
•
Put the pusher (8) into the chute so that
the V-shaped hole was put on the knife
inside the chute.
•
Put the pulp collector (12) under the lid
(5) in the following way: lean the collector
and place it under the insert (3 )and lid
(5), then push it towards the motor (1)
•
Put the juice collector (9) so that the
juice spout (f) was inside the collector
(9).
Attention
We call your attention to proper
assembling. The fin (g) of the insert (3)
should be in the same line as the cutting
on the bowl (2) and the cutting in the lid
(5).
Start-up and operation
•
Check if the switch is turned to „0"
position.
•
Plug the juice extractor in and start it up
with the switch (a) setting as necessary
gear 1 (position I - low rotation) or gear
2 (position II – high rotation).
•
Put some fruit or vegetables into chute
and press them slightly with the pusher.
15
Advertisement
