Troubleshooting - HoMedics BPW-710-CA Instruction Manual And Warranty Information

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
Unit does not
turn on when the
START/STOP
button is pushed.
EE measurement
error symbol shown
on display or the
blood pressure
value is displayed
excessively low
(or high).
E1 error symbol
shown on display
E2 error symbol
shown on display
E3 error symbol
shown on display
EP error symbol
shown on display
Note: If the unit still does not work, contact HoMedics Consumer
15-0150 BPW-710-CA_IM_v3--03.indd 26
SYMPTOMS
Batteries have
run down.
Battery polarities
have been positioned
incorrectly.
Cuff has been placed
incorrectly.
Did you talk or
move during
measurement?
Shaking of the wrist
with the cuff on.
Air circuit
abnormality.
Inflation pressure
exceeding 300 mmHg.
Error determining
measurement data.
System error.
Relations. Under no circumstance should you disassemble or
attempt to repair the unit by yourself. Contact information for
HoMedics Consumer Relations Department can be found on
the warranty page.
POSSIBLE
CAUSES
Replace them
with two new AAA LR03
alkaline batteries.
Re-insert the
batteries in the
correct positions.
Wrap the cuff properly
so that it is positioned
correctly. Measure again.
Keep wrist steady during
measurement. Measure
again.
Measure again.
Switch the unit off, then
measure again.
Measure again.
Measure again.
26
CORRECTION
2015/10/29 下午3:43