Installing The Cable Management Arm; Opening And Closing The Cable Management Arm Stop Bracket - Lenovo System x3750 M4 Installation Instructions Manual

Rack Rear

Installing the cable management arm

This topic provides information on how to install the cable management arm to the rack cabinet.
To install the cable management arm, complete the following steps:
1. Place the cable management arm on the cable management support bar.
2. Align the inner and outer tabs of the cable management arm with the inner and outer slots on the
slide rails.
3. Slide the cable management arm tabs into both the inside and the outside slots of the slide rail.
4. Push the tabs until they snap into place.
Rack Rear

Opening and closing the cable management arm stop bracket

This topic provides information about the cable management arm stop bracket.
To make it easier to rotate the cable management arm on and off the cable management support bar,
complete the following steps:
1. Open the cable management arm stop bracket by pushing the tabs located above and below the
support stop bracket.
2. Rotate the cable management arm away from the server after opening the support stop bracket.
12
Lenovo System x3750 M4 Rack Installation Instructions
Stop bracket