Table of Contents
Advertisement
SERVO, ESC,RX & BATTERY INSTALLATION
26.Use the same way to install the other servo.
Insert the foam spacer between two servos.
27.Connect the pushrods to the servo horn when
servos are in neutral position.
28.Adjust the small clevises and make sure all the
control surfaces are level.
29.Connect the motor wire, next attach the
controller( ESC-10 Shown) on the wall by using
the double side foam tape. Next, install the
controller switch.
30.Use switch plate as template to drill 2mm holes
at the molded slot. Secure switch with two
screws provided with ACE ESC-10 shown.
31.Connect all servo wires and controller wire.
Normally the throttle wire is pluged into channel
3 (Throttle). The servo wires plug into channel
1(Rudder) and channel 2 (Elevator).
9
Advertisement
Table of Contents
