Table of Contents
Advertisement
ASSEMBLY / FUSELAGE
13.Trail fit the horizontal tail and vertical tail in the
fuselage, epoxy them in place when satisfied.
Make sure they are perpendicular to each other.
Fuselage
14.Trial fit the plastic firewall on the front of
fuselage. Apply Epoxy at the rim of front fuselage
then glue the firewall in place.
15.Epoxy the skid in place as shown.
16.Epoxy two wing strut mounts at the bottom of
fuselage. Note the orientation of the mounts.
17.Insert the landing gear in the fuselage then
"Push-N-Lock" the landing gear retainer. Make
sure it locks into place.
18.Locate two fairing retainers and install the
retainer in place. Next inser t fairing to the
retainer and make sure the root of fairing contact
fuselage. You may cut two 2" long and 3/4" wide
tapes from the decal at blank area then tape the
leading edge of fairing on the landing gear.
5
2
7
Advertisement
Table of Contents
