For Best Results - Panasonic S-200PE2E5 Technical Data & Service Manual

8-11. For Best Results

Don't get the remote control too far away from the receiver.
This may cause a malfunction. Be sure to keep the remote control in the same room as the receiver.
Point the remote control at the receiver.
When the signal is received correctly it will beep one time.
Avoid locating the remote control where it is covered, such as behind a curtain.
Keep it out in the open.
8-12. Addresses
In both multi and single unit installations, when more than one indoor unit is installed in the same room with
a compatible remote control, addresses can be set up to avoid crosstalk. By setting the address switches on the
receivers and matching them with the number of addresses on the remote control, up to six indoor units can be
controlled separately with the remote control. (When using units in a flexible combination or operating multiple
units simultaneously, as they are operated at the same time, they cannot be controlled individually.)
• These settings are saved in nonvolatile memory in the remote control, so even when its batteries are changed,
the settings do not have to be made again.
Checking Addresses
When you press
corresponds to the address of a receiver, the buzzer sounds. (If it is on ALL, the buzzer will always sound.)
If it is on ALL, it can be operated regardless of receiver addresses. Point the remote control at the receiver you
wish to operate and transmit.
Matching up Addresses
Setting Remote Control Addresses
1. If you press
2. While holding
Set it to the receiver address switch of the indoor unit you wish to operate.
3. When you release
When you do this, if it corresponds to the receiver's address setting, the buzzer sounds.
Address
Display on the
Remote Control
CZ-RWSC.2
Position of
the Receiver's
Address Switch
8
NOTE
• Please do not hold the [Emergency Operation]
display lamps are blinking one after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to "ALL" at the time of the shipment.
on the remote control, its current address is shown in the display. If this address
and at the same time, "
down, every time you press
, the address that was displayed is set.
The position of the
receiver's address
switch does not
matter.
" will blink.
, it cycles from ALL
button of the indoor unit down while the indoor unit's
8-8
1 2 3...6 ALL.
For 1, 2 and 3, set
the switch on the
left and for 4, 5 and
6, to the right.