Setup-Menu - Dimplex FWS 27 Operating Instructions Manual

FWS 27
FWS Solartronic
Individual display values as follows:
Power limit
By short pressing of the setup button
water unit will be shown. After 12
seconds the display will turn back to the
last display.
Temperature protection
Information, if temperature protection is
activated or deactivated.
Operating cost
Indication of the total energy cost
consumption.
Operating cost per hour
Indication about the current energy
consumption given in Euro per hour.
Working time
Indication of total operating time of the
heating given in seconds / minutes /
days / years.
Standby time
Indication of the operating time since
latest connection of the appliance to the
supply voltage given in seconds /
minutes / days / years.
Lifetime counter
Indication of the total operating time of
the appliance given in seconds /
minutes / days / years.
Flow
Indication of current flow rate given in l/
min.
Temp in
Indication of inlet temperature in °C.
Temp out
Indication of outlet temperature in °C..
Pump power
Indication of the pump power ratein %.
Index value
Indication of the set temperature value
for the fresh water unit.
Power
Indication of current power
consumption in kW.
Control value
Indication of calibration value of the
control system.
Diagnostics
Indication of the last ten diagnostic
messages
Signal
Indication of the current 1
quality in %
Software version
Information about installed software
version.
the actual power rate of the direct
Do not use for computation!
2
C-connection
Note: Values of the service menu cannot be modified or
entered. Above mentioned values are only given for your
information!

5.4 Setup-menu

The setup menu offers a variety of adjustabilities, affecting the
performance and the display of the appliance.
Press the setup-key and the service-key
for at least 3 seconds to call up the setup-menu, the display
conforms by >Setup<.
Using the arrow keys
induvidual parameters. The setting mode of the individual
parameters enter (e.g. tone) is activated by presing the setup-
key , the display flashes. You can now select the new
parameter value with the arrow key
The new parameter value os stored when pressing the setup-
key again. With the service-key
standard display.
13
simultaeously
and you can switch over to the
and .
you will get back to the