Table of Contents
Advertisement
1.0
Introduction
The radios have been prepared to meet published speciÞcations through their manufacturing
process, with the use of laboratory-quality test equipment of highest accuracy. The recommended
Þeld service equipment approaches the accuracy of the manufacturing equipment with a few
exceptions.
Accuracy of the equipment must be maintained in compliance with the manufacturerÕs
recommended calibration schedule.
2.0
Setup
Supply voltage can be connected from the battery eliminator. The equipment required for alignment
procedures is connected as shown in the Radio Alignment Test Setup diagram.
Initial equipment control settings should be as indicated in the following table and should hold for all
alignment procedures except as noted in Table 4-1.
Monitor Mode: Power Monitor
RF Attn: -70
AM, CW, FM: FM
OÕscope Source: Mod
OÕscope Horiz: 10mSec/Div
OÕscope Vert: 2.5kHz/Div
OÕscope Trig: Auto
Monitor Image: Hi
Monitor BW: Nar
Monitor Squelch: mid CW
Monitor Vol: 1/4 CW
Table 4-1 Initial Equipment Control Settings
Service Monitor
PERFORMANCE TESTING
Test Set
Power Supply
Spkr set: A
Voltage: 7.5Vdc
Spkr/load:
DC on/standby:
Speaker
Standby
PTT: OFF
Volt Range: 10V
Current: 2.5A
Chapter 4
Hide quick links:
Advertisement
Table of Contents
