Stanley SCL-D Instructions Manual page 9

Keypad, Modes, and LED
Keypads (See figure )
D
Power ON / OFF / Mode Key
Pulse Mode ON / OFF Key
Modes (See figure )
E
Available Modes (SCL)
• Horizontal Line
• Vertical Line
• Horizontal Line and Vertical Line (Cross)
• All beams OFF
Available Modes (SCL-D)
• Horizontal Line
• Vertical Line
• Horizontal Line and Vertical Line (Cross)
• Up and Down Dot Beam
• All Line and Dot
• All beams OFF
LEDs (See figure )
D
Power LED - Solid GREEN
• Power is ON
Power LED - Blinking RED
• Low Battery
Power LED - Solid RED
• Replace Battery / Battery Needs Recharging
Level LED - Blinking RED
• Out of Compensation Range
Pulse LED - Solid GREEN
• Pulse Mode is ON
(Can be used with Detector)
Applications
Plumb / Point Transfer
• Using the vertical laser beam, establish a vertical
reference plane.
• Position the desired object(s) until they are aligned
with the vertical reference plane to ensure object(s)
are plumb.
• Establish 2 reference points that need to be plumb.
• Align either the down laser beam or the up laser beam to
a set reference point.
• The opposing laser beam(s) will be projecting a point
which is plumb.
• Position the desired object until the laser beam is
aligned with the second reference point that needs to be
plumb with the set reference point.
Level / Point Transfer
• Using the horizontal laser beam, establish a horizontal
reference plane.
• Position the desired object(s) until they are aligned
with the horizontal reference plane to ensure object(s)
are level.
Square
• Using the vertical and horizontal laser beams, establish
a point where the 2 beams cross.
• Position the desired object(s) until they are aligned with
both the vertical and horizontal laser beams to ensure
object(s) are square.
Pulse Mode (See figure
• Setting laser tool to pulse mode allows use with
optional laser detectors.
)
F
FMHT77321 9