Batteries And Power - Stanley SCL-D Instructions Manual

Batteries and Power

Battery Installation / Removal (See figure
Laser Tool
• Turn laser tool to battery door and open.
• Install / Remove batteries. Orient batteries correctly
when placing into battery compartment.
• Close battery door. Be sure that the door has been
closed securely.
WARNING:
• Pay close attention to the battery holder's (+)
and (-) markings for proper battery insertion.
Batteries must be of same type and capacity. Do
not use a combination of batteries with different
capacities remaining.
10 FMHT77321
Set Up
) Laser Tool
B
• Place laser tool on a flat, stable surface.
• If using the auto levelling feature move the pendulum
Mounting on Accessories
• Position accessory in a place where it will not be easily
• Set up the accessory as required. Adjust positioning to
• Mount the laser tool to the accessory using the
NOTE:
• It is best practice to always support laser tool with
one hand when placing or removing laser tool from an
accessory.
• If positioning over a target, partially tighten the fastening
screw, align laser tool, and then fully tighten.
/ transport lock to the unlocked position. The laser tool
must then be positioned in its upright position on a
surface that is within the specified compensation range.
disturbed and near the central location of the area to
be measured.
be sure accessory base is near horizontal (within laser
tools compensation range).
appropriate fastening method to be used with such
accessory / laser tool combination.
CAUTION:
• Do not leave the laser tool unattended on an
accessory without fully tightening the fastening
screw. Failing to do so may lead to the laser tool
falling and sustaining possible damage.