Hilti TE 30-A36 Original Operating Instructions page 11

3.3 Active Torque Control
In addition to the mechanical slip clutch, the combihammer is also equipped with ATC (Active Torque Control).
This system provides additional drilling safety and convenience as it causes rapid shutdown upon sudden
rotation of the combihammer about the drill bit axis. This may occur, for example, when the drill bit sticks
due to hitting a rebar or when the drill bit is tilted unintentionally.
Always choose a working position in which the body of the power tool, when running in a forward direction
(clockwise), is free to rotate in a counterclockwise direction (as seen by the operator). When running in
reverse, the tool reacts to sudden clockwise rotation. If rotational movement is not possible, the ATC system
cannot react.
3.4 Lithium­ion battery status display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Li­ion battery. The charge status of the Li­ion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light up.
3 LEDs light up.
2 LEDs light up.
1 LED lights.
1 LED blinks.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Note
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.5 Items supplied
Combihammer, side handle, depth gauge, operating instructions.
Note
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Center or online at: www.hilti.com
4 Technical data
4.1 Combihammer
Rated voltage
Weight
Single impact energy
Drilling diameter range in concrete/masonry (hammer
drilling)
Drilling diameter range in concrete/masonry (hammer
drilling)
Drilling diameter range in wood (solid)
Drilling diameter range in wood (solid)
2
Meaning
• Charge state: 75 % to 100 %
• Charge state: 50 % to 75 %
• Charge state: 25 % to 50 %
• Charge state: 10 % to 25 %
• Charge state: < 10 %
• The battery has overheated or is completely
discharged.
• The power tool is overloaded or has overheated.
TE 30­A36
36 V
12.1 lb
(5.5 kg)
3.6 J
1/4 in ... 1 1/8 in
6 mm ... 28 mm
1/8 in ... 1 in
3 mm ... 25 mm
5