Black & Decker KC9036 Manual page 11

A pilot hole guides the screw
and prevents splintering or
distortion of the wood. For the
optimum size of the pilot hole,
refer to the table below.
When screwing in hardwood,
also drill a clearance hole with
a depth equal to half the
length of the screw. For the
optimum size of the clearance
hole, refer to the table below.
Screw size
No. 6 (3.5 mm)
No. 8 (4 mm)
No. 10 (5 mm)
Screw size
No. 6 (3.5 mm)
No. 8 (4 mm)
No. 10 (5 mm)
Screw size
No. 6 (3.5 mm)
No. 8 (4 mm)
No. 10 (5 mm)
MAINTENANCE
Your Black & Decker tool has
been designed to operate over a
long period of time with a
minimum of maintenance.
Continuous satisfactory operation
depends upon proper tool care
and regular cleaning.
Your charger does not require
any maintenance apart from
regular cleaning.
Unplug the charger before
cleaning it.
Regularly clean the ventilation
slots in your tool using a soft
brush or dry cloth.
Regularly clean the motor
housing using a damp cloth.
Do not use any abrasive or
solvent-based cleaner.
KC9036EUR.PM65
PROTECTING
THE ENVIRONMENT
Tools
Should you find one day that
your tool needs replacement,
or if it is of no further use to
you, think of the protection of
the environment.
Black & Decker repair agents
will accept old Black &
Pilot hole ø Decker tools and ensure that
(softwood) they are disposed of in an
2 mm environmentally safe way.
3.2 mm
3.5 mm Battery (fig. G)
Pilot hole ø If you want to dispose of the
(hardwood) tool yourself, the battery
Cd
2.5 mm must be removed as
3.5 mm described below and
4.0 mm disposed of in accordance
with local regulations.
Clearance
Do not short-circuit the
hole
4 mm battery terminals. Do not use
tools to remove the battery;
5.0 mm
only use your fingers.
5.7 mm
Hold the tool as shown in fig. G.
Gently knock the battery
cover against a hard surface
such as a workbench to
loosen the cover.
Remove the cover.
Pull the battery out and
disconnect the wires to
remove it from the tool.
Place the battery in a suitable
packaging to ensure that the
terminals cannot be short-
circuited. Take the battery to
your service agent or a local
recycling station. Collected
batteries will be recycled or
disposed of properly.
11
E N G L I S H
11
25-06-2001, 14:53