Soft Dry Operation - Panasonic CS-PC12QKH Service Manual

13.2 Soft Dry Operation


Soft Dry operation can be set using remote control.

Soft Dry operation is applied to dehumidify and to perform a gentle cooling to the room.

This operation starts when the intake air temperature sensor reaches -1.5°C from the setting temperature on the
remote control.

When operation begins, Soft Dry will be switched "ON" for a maximum 10 minutes, then Soft Dry operation will be
turned "OFF" for a minimum 6 minutes. After that, the Soft Dry operation will be "ON" and "OFF" based on the
setting temperature as shown in figure below.

However after 3 minutes of compressor off, during Soft Dry "OFF" (within 6 minutes Soft Dry restart control), the
indoor unit will start to operate at normal Cooling mode if the intake temperature is higher than Cooling "ON"
point.
13.2.1 Soft Dry Operation Time Diagram (For PC9/12QKH)
59