Troubleshooting; Cleaning The Spray Arms - Electrolux ESI 45010 User Manual

9.2 Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.
9.3 External cleaning
Clean the appliance with a moist soft
cloth.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
Alarm code
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 1 time in-
termittently.
Downloaded from DishWasher-Manual.com Manuals
2.
3.
4.
A
5.
1
A
2
6.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
With some problems, different indica-
tors flash continuously or intermit-
tently at the same time to show an
alarm code.
Problem
The appliance does not fill with water.
To disassemble the filter (A), pull
apart (A1) and (A2).
Remove the filter (B).
Wash the filters with water.
Put the filter (B) to its initial position.
Make sure that it assembles correctly
under the two guides (C).
Assemble the filter (A) and put it into
position in filter (B). Turn it clockwise
until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
ENGLISH 13