Setting Mode - Electrolux ESI 45010 User Manual

10 www.electrolux.com
7.1 Using the detergent
A
7.2 Setting and starting a
programme

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators are on
and the display shows 3 horizontal sta-
tus bars.
If the control panel shows other condi-
tions, press and hold function buttons (B)
and (C) at the same time until the appli-
ance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. To set a programme, keep the appli-
ance door ajar.
3. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
4. Press the button of the programme
you want to set.
• The related programme indicator
stays on while all the other pro-
gramme indicators go off.
• The display shows 3 horizontal sta-
tus bars.
• The wash indicator comes on.
5. Close the appliance door. The pro-
gramme starts.
Downloaded from DishWasher-Manual.com Manuals
B
30 A
20
+ -
C
1.
Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
• The display shows 1 horizontal sta-
tus bar.
Starting a programme with delay
start
1. Set the programme.
2. Press the delay button again and
again until the display shows the delay
time you want to set (from 1 to 9
hours).
• The delay time flashes in the dis-
play.
3. Close the appliance door. The count-
down starts.
• The delay time comes on with fixed
light and starts to decrease with
steps of 1 hour.
• The wash indicator goes off.
• When the countdown is completed, the
programme starts.
– The wash indicator comes on.
– The display shows 1 horizontal status
bar.
You can set a programme and the
delay start also with the appliance
door closed. In this condition, you
have only 3 seconds after each
setting before the appliance starts
to operate.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.