Sealer Information - Jeep COMPASS Repair Manual

APPLICATION RECOMMENDATIONS
ALL REPAIRS WHERE PANELS WERE REPLACED HAVE VOIDS THAT MUST
BE FILLED WITH SEALANT. SEALANT SHOULD BE APPLIED TO ALL SKIPS,
PIN HOLES, IN SEALERS AND WELD BURN THROUGH HOLES ON THE INTE-
RIOR AND EXTERIOR OF TH VEHICLE THAT WOULD PERMIT LEAKAGE OF
WATER, AIR OR EXHAUST FUMES. TYPICAL AREAS OF THE EXTERIOR
THAT MUST BE SEALED ARE LISTED IN THIS SECTION. AREAS OF THE
INTERIOR THAT MUST BE SEALED ARE FLOOR PANS, WHEELHOUSES,
DASH PANEL, AND COWL SIDES.

SEALER INFORMATION

4mm DIA* X 1000mm
PUMPABLE
* = DIAMETER
SEALER AMOUNT/BEAD SIZE
Back to Index