Install Uponor Smatrix Move/Move Plus; Installation Procedure - Uponor SmatrixMove Installation And Operaion Manual

UK
4

Install Uponor Smatrix Move/Move PLUS

CZ
DE
4.1

Installation procedure

DK
Uponor Smatrix Move
Uponor recommends following the process described
below to guarantee the best possible installation results.
EE
Stage Procedure
1 Prepare for installation
ES
2 Install Uponor Smatrix Move/Move PLUS
controller
3 Finishing installation
FI
Uponor Smatrix Move PLUS
Uponor recommends following the process described
FR
below to guarantee the best possible installation results.
Stage Procedure
HR
1 Prepare for installation
2 Install Uponor Smatrix Move/Move PLUS
controller
HU
3 Install Uponor Smatrix Wave/Wave PLUS
thermostats and sensors
4 Finishing installation
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
1 2
4.2
Before starting the installation:
•
Page
12
•
19
37
•
To determine where to best place the Uponor Smatrix
Move/Move PLUS components, follow these guidelines:
•
Page
12 •
19
27
•
37
•
U P O N O R S M AT R I X M O V E / M O V E P L U S · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
Prepare for installation
Verify the contents of the package with the packing
list.
See also section 3.3 Uponor Smatrix Move/Move
PLUS components for identification of components.
Check whether an external temperature sensor is
to be installed with a compatible thermostat (Move
PLUS only).
Study the wiring diagram in the end of this manual.
Ensure that the controller can be installed close to
the mixing valve actuator or pump.
Ensure that the controller can be mounted close
to a 230 V AC wall socket, or if required by local
regulations to a junction box, connected to the
mains power.
Ensure that installed components are protected
from running or dripping water.
We recommend that the Uponor Smatrix Move
PLUS antenna is mounted in vertical position.