Indesit tcud93b Service Information page 31

Indesit Company
PROGRAMMING (Using Smartcard Reader / Card)
If the Main Module has been replaced during a repair the board will require programming using the
following method.
1. Do NOT connect the dryer to electrical supply at
this point.
2. Insert the pre-programmed card into the Card
reader. Care must be taken at this point to ensure
the card is inserted correctly with the Chip on the
card facing the PCB of the Reader.
3. Insert the Reader and Card into module connection
port located at the front of the dryer - see photo.
4. Connect the dryer to the Electrical
The LEDs on the Smart Card Reader will light in
this sequence:
a. Red ON: Good Communication between Smart
Card Reader and Card. See also Note 1 below.
b. Red OFF; Green
c. At end, Green ON = Download OK, module
programmed, Red
6. Disconnect the appliance from the electricity
supply.
7. Remove the Smart Card Reader.
8. Connect the appliance to the Electrical supply.
Note 1.
a If the Red LED is flashing SLOWLY, a card is
inserted but either the card is blank (previously
used), is incorrectly inserted or there is a poor
connection between the card and card reader.
b If the Red LED is flashing RAPIDLY, a card is
NOT inserted or not inserted fully.
Service Manual UK
supply;
Blinking: Download taking place.
ON = Download NOT
31 of 37
and Smart Card in use
OK.
Module
Connection
Port
Smart Card Reader
SmartCard
SmartCard
Reader
English