Control Board Programming - Indesit tcud93b Service Information

Indesit Company
CONTROL BOARD PROGRAMMING for Modules with fixed EEProm
NOTE: This board does NOT have a physically replaceable EEProm.
Programming a Main Board
There are a number of ways the board can be programmed - some of which are not applicable to
certain markets.
Types of programming:
1. Handheld Terminal (Not UK)
2. Emit / Memwriter (UK Indesit Service Engineers)
3. Smart Reader & Smart Card (certain areas of UK market) see photo below and following page.
Smart
Card
Reader
PROGRAMMING (Using EMIT)
This machine can be programmed via the Emit PC, using a USB lead (Part No. C00289046),
Hardware key (Part No. C00289048) and the Memwriter software.
USB Hardware Key and USB Cable
Part No. C00289046
A
Service Manual UK
Part No. C00289048
Connector pins are NOT replaceable
30 of 37
Smart Card
this card holds
the program file
and can ONLY
be used ONCE.
After the module
has been programmed
the card is automatically
erased.
A = USB connector
B = not used
A
B
English