Tips On Saving Energy; Service Programme - Bosch TES 501 Instruction Manual

7. Thoroughly clean the brewing unit sieve
under the running water.
Important: Do not clean with detergent or
other cleaning agents and do not put it in
the dishwasher.
8� Wipe out the inside of the appliance
thoroughly with a damp cloth and
remove any coffee residues.
9� Allow the brewing unit (5a) and the
i nterior of the appliance to dry.
10� Replace the cover (5e) on the brewing
unit and reinsert the brewing unit (5a)
fully into the appliance.
11� Press the eject lever (5c) up fully.
12� Slide the red lock (5d) fully to the right
and close the door (5b).

Tips on saving energy

● Switch off the fully automatic espresso
machine when not in use. To do this,
press the service button (12). The appli-
ance rinses and switches off.
● If possible, do not interrupt coffee or milk
froth dispensing. Stopping a process
prematurely results in higher energy
consumption and the drip tray fills up
more quickly.
● Descale the appliance regularly to avoid
a build-up of limescale. Limescale residue
results in higher energy consumption.

Service programme

Duration: approx. 35 minutes
Depending on use, the service button (12)
flashes at certain intervals.
The appliance should be cleaned and
descaled immediately using the service
programme. If the service programme is
not run as instructed, the appliance may
be damaged.
¡
Warning!
Follow the instructions for using the
d escaling and cleaning agents for each
service programme. Please observe the
safety instructions on the packaging of
the cleaning agent.
Never interrupt the service programme.
Do not drink the liquids.
Never use vinegar, vinegar-based products,
citric acid or citric acid-based products.
Never put descaling tablets or other
d escaling agents in the drawer (4).
Specially developed and suitable
descaling and cleaning tablets are
available from retailers or customer
service (see "Accessories").
Important: If there is a water filter in the
water tank (16), it must be removed before
starting the service programme. Clean the
brewing unit before starting the service
programme, see chapter "Cleaning the
brewing unit".
To start the service programme, press and
hold the service button (12) for at least
5 seconds�
Information: The service button (12)
flashes while the programme is running.
H
LED lights up.
● Empty the drip tray (8) and reinsert it.
The appliance rinses twice.
en
15