Operating The Unit By Tv's Remote Control (Hdmi Control) - Yamaha YAS-706 Series Owner's Manual

Operating the unit by TV's remote control (HDMI control)

The HDMI control function (link function) coordinates operation of a TV and the unit so that the unit can be operated using the TV's remote control.
When a TV is connected to the unit with an HDMI cable (p. 12), the TV's remote control can be used to perform the following operations.
Coordinated functions via the TV remote control
1. Turn on/off
Both the TV and this unit turn on/off at the same time.
2. Switch input sources
• The unit's input source switches accordingly when the TV's input source
is switched.
Examples
– When a TV program is selected on the TV, the unit's audio input
source is switched to the HDMI OUT (ARC) jack using the ARC
function or TV jack.
– When a BD/DVD player is connected to the HDMI IN 1–2 jack on the
unit, the unit's input source switches to HDMI when the BD/DVD player
is selected with the TV's remote control.
• The input source can be switched while the unit is off.
3. Switch the audio output device (TV or this unit (amplifier))
4. Adjust volume
This unit's volume can be adjusted when the TV's audio output is
set to this unit (amplifier).
HINT
• Even if your TV supports the HDMI control function, some functions may not be available. For details, refer
Remote control of TV (Example)
to documentation supplied with your TV.
• We suggest using devices (TV, BD/DVD player, etc.) from the same manufacturer.
If the unit cannot be operated with the TV's remote control
Confirm the settings are properly configured as described below.
– The HDMI control function of this unit is enabled (p. 46).
– The HDMI control function is enabled on the TV.
Examples of TV settings
• From the setup menu on your TV, select "Link setting" ➔ "HDMI control setting", then set a setting
such as "HDMI control function" to "ON".
• Set audio output to any option other than TV.
If the unit cannot be operated with the TV's remote control even after the settings described above have
been applied correctly:
– Turn off this unit and the TV, and then turn them back on again.
– Disconnect the power cable of the unit and external devices connected to the unit via HDMI cable. Plug
them in again after about 30 seconds.
PLAYBACK ➤ Operations
En
22