Yamaha YAS-706 Series Owner's Manual page 61

Problem
The Internet radio cannot be played.
The dedicated apps for mobile device does
not detect the unit.
Firmware update via the network (Network
Update) fails.
The iPod does not recognize the unit when
using AirPlay.
The app installed on a mobile device does not
recognize the unit.
The unit cannot connect to the Internet via a
wireless router (access point).
Wireless network is not found.
Cause
The selected Internet radio station is currently not available.
The selected Internet radio station is currently broadcasting silence.
Access to the network is restricted by the firewall settings of your
network devices (such as the router).
The MAC address filter is enabled on the unit.
The unit and mobile device are not in the same network.
It may not be possible depending on the condition of the network.
The unit and iPod/mobile device are connected to different SSIDs on
the same access point.
The wireless router (access point) is turned off.
The unit and the wireless router (access point) are too far apart.
There is an obstacle between the unit and the wireless router (access
point).
There is a device (microwave oven, wireless LAN, etc.) outputs signals
in the 2.4 GHz frequency band nearby.
Access to the network is restricted by the firewall settings of the
wireless router (access point).
Remedy
There may be a network problem at the radio station, or the service may have
been stopped. Try the station later or select another station.
Some Internet radio stations broadcast silence at certain of times of the day.
Try the station later or select another station.
Check the firewall settings of your network devices. The Internet radio can be
played only when it passes through the port designated by each radio station.
The port number varies depending on the radio station.
In "MAC Address Filter" in the setup menu, disable the MAC address filter or
specify the MAC address of your mobile device to allow it to access to the unit
(p. 48).
Check the network connections and your router settings, and then connect
the unit and mobile device to the same network.
Update the firmware via the network (Network Update) again or use a USB
flash drive (p. 52).
Check the network connections for the unit and your mobile device, and
connect them to the same SSID.
Turn on the wireless router (access point).
Place the unit and the wireless router (access point) closer to each other.
Move the unit and the wireless router (access point) in a location where there
are no obstacles between them.
Move this unit away from the device that is emitting radio frequency signals.
Check the firewall setting of the wireless router (access point).
APPENDIX ➤ Troubleshooting
61
En