Remote Control - Yamaha YAS-706 Series Owner's Manual

Audio/Video
Problem
The image is not displayed on TV screen.
Menu screen of this unit is not displayed.
A digital or high-frequency equipment
produces noises.
The HDMI control function does not work
properly.
When the unit is turned off, video and/or
audio from a playback device are not output
to the TV.
Audio delay control function is not effective
even "Audio Delay" is set to "Auto".

Remote control

Problem
The unit cannot be operated using the remote
control.
The TV cannot be operated when the TV's
remote control is pointed toward the unit's
remote sensor.
Cause
The HDMI cable is not securely connected.
4K mode is not properly configured.
The input switch of TV is not set correctly.
The unit may be placed close to digital equipment or high-frequency
equipment.
"HDMI Control" is set to "Off".
The HDMI control function is disabled on your TV.
The number of the connected HDMI devices exceeds the limit.
Amplifiers (AV amplifiers, sound bars, etc.) other than the unit are
connected to the TV or a playback device with an HDMI cable.
"HDMI Control" is set to "Off".
The TV does not support the audio delay auto adjustment feature.
Cause
The unit is out of the operating range.
The batteries are weak.
The remote control sensor of the unit is exposed to direct sunlight or
strong lighting.
The unit and TV are too far apart (or too close), preventing proper
operation of the unit's TV remote repeater function.
There are obstacles between the unit and the TV (cables, etc.),
preventing proper operation of the unit's TV remote repeater function.
The TV's remote control does not use infrared signals.
Signals transmitted from the TV's remote control and the unit's TV
remote repeater interfere with each other, making it difficult for the TV
to receive signals.
Remedy
Connect the HDMI cable properly (p. 12, 13).
Select Mode 1 or Mode 2 in accordance with the 4K signal format (p. 51).
Set the TV's input source to this unit (p. 16).
Move the equipment away from the unit.
Set "HDMI Control" to "On" (p. 46).
Refer to documentation supplied with your TV and check the setting.
Disconnect some of the HDMI devices.
Connect only this unit to the TV or a playback device for use as an amplifier.
Set "HDMI Control" to "On" (p. 46).
Adjust timing of sound output manually from "Audio Delay" in the setup menu
(p. 45).
Remedy
Use the remote control within the operating range (p. 3).
Replace with new batteries (p. 3).
Adjust the lighting angle, or reposition the unit.
Position the unit so that it is more than 5 cm (2 in) away from the TV (p. 10).
Remove obstacles between the unit and the TV.
The unit's TV remote repeater function cannot be used. Reposition the unit so
that it does not obstruct the remote control sensor on the TV, and point the
TV's remote control at the remote control sensor on the TV to control the TV.
APPENDIX ➤ Troubleshooting
57
En