Comparison Chart - NCR 7197 II SERIES Owner's Manual

7197 Series II Owner's Guide
1D 0E
1D 0F
1D 10 n
1D 11 aL aH cL cH
d1...dn
1D FF

Comparison Chart

The following table details the list of commands whose behavior differs from the 7193 and
the 7197 Series II because of the physical differences of a 6 dots/mm head (7193) versus
an 8 dots/mm head (7197 Series II).
15 n
16 n
1B 20 n
1B 24 n1 n2
1B 26 s c1 c2 n1 d1...nn
dn]
1B 2A m n1 n2 d1...dn
1B 33 n
Erase the Flash Memory
Return Main Program Flash CRC
Erase Selected Flash Sector
Download to Active Flash Sector
Reboot the Printer
Command
Feed n Dot Rows
Add n Extra Dot Rows
Set Right-Side Character
Spacing
Set Absolute Starting Position
Define User-Defined
Character Set
Select Bit Image Mode
Set Line Spacing
Description Difference between 7193 and 7197
configured in 7193 Emulation Mode.
This command will move
the paper on the receipt in
n/203 inch steps instead of
n/152 inch steps.
The dot rows will be
measured in n/203 inches
versus n/152 inches.
This command sets the right
side spacing to "n"
horizontal motion units. By
default, these units are in
terms of 1/203 inches versus
1/152 inches.
For graphics commands, the
position is scaled to best
7193. In text mode, the
equivalent character position
is calculated.
Since the dots on the 7197
Series II print head are
smaller, user-defined
characters that were used on
the previous printer will
appear smaller on the 7197
Series II printer.
In 7193 Emulation Mode,
graphics are scaled to best
match the size of the graphic
in the 7193 printer.
This command uses n in
terms of n/360 inches. Since
August 2011
Chapter 6: Commands
193
193
194
195
196
Series II
78