Cisco 860 Installing Manual page 15

Chapter 2 Installing the Router
Figure 2-14
1
2
3
4
Mounting the Cisco 812 ISR on a Hard Ceiling or a Wall
This procedure describes the steps required to mount the Cisco 812 ISR on a ceiling constructed of
3/4-inch (19.05 mm) or thicker plywood using #8 fasteners using the universal mounting bracket
(C810-BR-CM).
The Cisco 812 ISR integrated antennas perform best when the router is mounted on horizontal surfaces
Note
such as a table top or ceiling. For advanced features such as voice, location, and router detection, ceiling
mounting is strongly recommended. However, for smaller areas such as conference rooms, kiosks,
transportation environments, or hot-spot usage where data coverage is the primary concern, the unit may
be wall mounted using wall anchors or screws.
Suspended Ceiling Mounting Details
To PoE+ power source
Ceiling T-rail
Ceiling tile with opening cut for
cables
Power cable to PoE+ splitter
1
4
5 GE CAT5 cable to PoE+ splitter
6 Power and GE cable routed through a ceiling
mounting bracket and into the router so that the
cabling is hidden from directly below
7 Ceiling grip clip
8 Ceiling mount bracket
Cisco Integrated Services Router Hardware Installation Guide
Installing the Cisco 810 ISR
7 8
5 3 6
2
2-15