Mounting and commissioning the machine
● Move bearing plate 6 of the motor, so that toothed belt 5 is stretched.
● In this position tighten screws 7.
● Turn the balance wheel in sewing direction until the needle point descending from above,
● Conclude the input.
8
Mounting the belt guard of the flange motor
.02.05
8 - 6
Fig. 8 - 07
is level with the top edge of the needle plate and re-check the value. A tolerance of
± 2 increments is allowed.
1
Fig. 8 - 08
7
● Attach belt guard 1 with screws 2 and 3.
2
3
7
5
4
6