Husqvarna SMR 511 2012 I.E. Specifications - Operation - Maintenance page 97

REPLACING THE NUMBER PLATE BULB
- loosen screw (1) and remove the number plate bulb
(2) from the mudguard;
- take bulb holder (3) and bulb (4) out of the support;
- pull the bulb (4) to detach it from bulb holder.
Once the bulb has been replaced, reverse the above pro-
cedure to reassemble.
HEADLIGHT ADJUSTMENT
When checking the proper aiming of the headlight beam:
inflate tyres at the right pressure, have a person sit
astride the motorcycle and set the motorcycle perpen-
dicular to its longitudinal axis
In front of a wall or a screen positioned at a distance of
10 metres (32.8 ft), draw a horizontal line correspond-
ing to headlight centre height, and a vertical line aligned
with vehicle longitudinal axis.
If possible, execute this operation in a shaded place.
When the low beam is on, the upper edge between dark
and lit zone should be at 9/10th of headlight centre
2
from ground.
1
3
4
Beam height can be adjusted as follows:
- Work adjuster screw (1);
tighten to lower the beam,
loosen to raise the beam.
Once set, reverse the above procedure to reassemble.
1
SPECIFICATIONS - OPERATION - MAINTENANCE EN - 47