Husqvarna SMR 511 2012 I.E. Specifications - Operation - Maintenance page 75

THROTTLE CONTROL CABLE ADJUSTMENT
To check the correct adjustment of the throttle control
cable, operate as follows:
- loosen screws (1) and remove protective cap (2);
- turn throttle twistgrip (3) and make sure that there is
a clearance of approx. 2 mm (0.08 in);
- should this not be the case, loosen check nuts (4) and (5);
- turn and keep twistgrip (3) in the fully closed position;
- loosen upper "return" cable (6) using adjuster screw (7);
- keeping twistgrip (3) fully closed, reset cable (6)
clearance by turning adjuster screw (7);
- tighten check nut (4);
- turn adjuster screw (8) until reaching an opening
clearance of approx. 2 mm (0.08 in);
- tighten check nut (5);
- reassemble all parts, in the reverse order compared
to disassembly.
2
WARNING*: Operation with damaged
throttle control cable could result in an
unsafe riding condition.
3
2 mm
(0,08 in)
7
8
5
1
4
6
SPECIFICATIONS - OPERATION - MAINTENANCE EN - 25